| Server IP : 79.170.40.229 / Your IP : 18.116.88.178 Web Server : Apache System : Linux web232.extendcp.co.uk 4.18.0-513.24.1.el8_9.x86_64 #1 SMP Mon Apr 8 11:23:13 EDT 2024 x86_64 User : 1stforcarhirealicante.com ( 296923) PHP Version : 5.6.40 Disable Function : NONE MySQL : ON | cURL : ON | WGET : ON | Perl : ON | Python : ON | Sudo : ON | Pkexec : ON Directory : /proc/thread-self/root/var/log/ |
Upload File : |
# Debug Level : 0 is Default Debug, 2 is highest level DEBUGLEVEL=0 # Debug Level 2 Mask: if bit is set then mask off value #DEBUGLEVEL2MASK=0x400 DEBUGLEVEL2MASK=0 # Directory to drop off the Debug file in, File is named #DEBUGDIR=. # Set size of logs rotation in KB #ROTATELOGSIZE=1000 # Set it to disable debug logging DISABLELOG=0 # SCSI Filters for OOB: SL_SCSI_FILTER_VPD_83 = 0x01 SL_SCSI_FILTER_VPD_B1 = 0x02 # SL_SCSI_FILTER_INQUIRY_DATA = 0x04 SCSICOMMANDFILTER=0x00 OVERWRITE=0 SIMULATION=0 SCSI_COMMAND_RETRY_COUNT=10 # Enclosure Event Polling Timer (and Poll for drive FW change) in seconds # value of 0 means no polling ENCLOSUREPOLLING=300 # PCIe specific # Avago Vendor ID VENDORID=0x1000 # Gen-3.5 IT Controller device IDs list # 0xAA 0xAB 0xAC 0xAD 0xAE 0xAF 0XD1 # Gen-4 IT Controller device IDs list # 0xE1 0xE2 0xE5 0xE6 DEVICEIDS=0xAC 0xAF 0xE1 0xE5 # For few of the cmds (e.g., SES page to obtain valid slot count, etc) # the following value may not be sufficient and needs to be adjusted/tuned # to a higher value. Pick a value until desired result is obtained. MAXDRVRBUFSIZE=765 # Set fw download chunk: 512 FWDOWNLOADSIZE=512 # Set fw download timeout FWDOWNLOADTIMEOUT=10 # EID List callback invocation timeout in seconds EIDLISTCALLBACKINTERVAL=30 # I2C Specific # Maximum I2C Buffer size for Writes from BMC to Controller I2CMAXWRITESIZE=32 # Maximum I2C Buffer size for Reads to BMC from Controller I2CMAXREADSIZE=32 I2CMAXREADWRITESIZE=36 # I2C BMC address - OEM provided information #I2CBMCI2CADDRESS=5 # Number of retries to be done at lowest I2C layer in case of error I2C_RETRY_COUNT=3 # Delay after sending last write, and before sending first I2C Read # This delay will be for all non-SCSI requests. Time is in milliseconds I2C_DELAY_FOR_CONFIG=25 # Delay after sending last write, and before sending first I2C Read # This delay will be for all SCSI commands. Time is in milliseconds # Pick a value that gives SCSI commands time to complete the majority of the time # This will cutdown on I2C retries I2C_DELAY_FOR_DRIVE=25 # Firmware events polling interval in seconds I2C_FW_EVENTS_POLL_INTERVAL=5 # End of INI file